Door Assembly/Digital Programmer Circuit (D.p.c) (Fu) - Panasonic NN-CS894S Service Manual

6. Remove 3 screws holding steam heater on oven assy.
7. Raise steam heater slightly and take out steam heater.
8. Pull out 3 pipes slightly.
To install thermistor
NOTE:
Before installing thermistor, please fill enough silicon
grease into the installation hole of steam heater for
good conductibility.
NOTE:
To prevent pipe from slipping out after repairing, make
sure that insert the pipe all the way to the end.
4.5. Door assembly/Digital
programmer circuit (D.P.C)
(FU) & (D.P.C) (BU)
1. Remove left and right door key springs from door arm with
plier.
NOTE:
Support door before removing door springs.
4.5.1. To remove door C and door A
• Insert flat blade screwdriver to release hinge pin from
left hinge.
• Release catch hooks between door C and door A, to
detach the door C.
17
NN-CS894S