Table of Contents
Advertisement
OPERATION AND DIGITAL PROGRAMMER CIRCUIT TEST PROCEDURE
1. Clock Setting
1. Plug the power supply cord into
2. Tap | Clack| Pad.
3. Enter time of day (TOD) by tapping
. Tap |Clock| Pad.
wall receptacle.
appropriate 10/1/10] 1 pads.
TOD has now been registered into
the digital programmer circuit and
will count up by minutes.
55:85
2. Time Cooking/Two Stage
4. Tap
|Power|
pad
3 times
for
Medium power.
(2nd stage}
2. Tap
|Power]|
pad once for High
power.
(1st stage)
3. Set
for
5
seconds
by tapping
appropriate | 10] | 10] 1| pads.
1. Place a water load in the oven.
5. Set
for
10 seconds
by tapping
6. Tap | Start| pad.
7. When first stage cooking time has
8. When 2nd stage cooking time has
appropriate 10] 1{ 10/1! pads.
elapsed,
oven
automatically
switches to 2nd stage cooking.
elapsed, oven beeps 5 times and
shuts off.
« TOD reappears in the display win-
dow.
3. Convection Cooking with Preheat
1. Tap
pad twice.
2. Tap
pad.
3. When
preheating
is completed,
4. After completion of preheating, be
oven beeps 3 times.
sure 10 open the door.
"P" begins to blink.
5. Close the door and set bake cook-
6. Tap
pad.
ing time for 2 minutes.
NOTE: NN-3559 accessory dispiay is not appeared.
Advertisement
Table of Contents
