Advertisement
Headhopnes
A headphone jack socket is provided (located on the front of the AAA-30
& AAA-60 and on the rear of the others) to allow stereo headphones to be
plugged into the amplifier for silent practice. Just use the speaker mute switch
located on the rear of the amp.
LINE IN
A single balanced line input is provided (located on the front of the AAA-30 &
AAA-60 and on the rear of the others) for play along practice. Used in conjunc-
tion with the Headphones socket for silent practice (Also see, AUX MIX).
AUX MIX
Set the level of your Backing Track by using the 'AUX MIX' Rotary control
provided.
MASTER
Use the output level control to adjust the playing volume of the amplifier.
REAR PANEL FACILITIES:
DI
There is a balanced post EQ Di fitted to all models expect the AAA-30, This
provides a balanced out put for connecting to a PA or for recording purposes.
This is located on the rear on the AAA-120 & AAA-300 and on the top panel of
the AAA-60.
FX Send & Return
On the AAA-120 & AAA-300 models there is an FX loop fitted for use with FX
pedals, a send and return is provided.
Speaker & Tweeter Mute
There is a speaker mute switch fitted to all models for use in silent practice.
On the AAA-120 and AAA-300 there is also a tweeter mute switch to cut the
tweeter if desired.
Speaker Out
There is an 8Ohm min load speaker out put located on the rear of the AAA-60
and also the AAA-300 for use with an 8 Ohm extension speaker only.
Fused mains inlet socket
This is for connection of the unit to your countries mains power supply. Please
ensure that the type and rating of mains fuse marked on the rear panel is used
when this is replaced.
Power switch
The power to the unit is turned on with the rear panel power switch. A power
led on the front panel will light to indicate that the amplifier is switched on.
SPECIFICATION:
AAA-30-8
Output Power
30watts rms into 8 ohms
Speaker Unit
1 x 8" Ashdown Driver
Input Impedance
1 Meg ohm
Input Signal Range 100Mv to 10v
E.Q.
Passive Bass, Middle, Treble.
AAA-60-10T
Output Power
60watts rms into 8 ohms
Speaker Unit
1 x 10" Ashdown Driver & Tweeter
Input Impedance
1 Meg ohm
Input Signal Range 100Mv to 10v
E.Q.
Passive Bass, Middle, Treble.
AAA-120-15T
Output Power
120watts rms into 8 ohms
Speaker Unit
1 x 15" Ashdown Driver & Tweeter
Input Impedance
1 Meg ohm
Input Signal Range 100Mv to 10v
E.Q.
Bass, Hi-Mid, Lo-Mid, Treble & Variable Mid Sweep
AAA-300-210T
Output Power
300watts rms into 8 ohms
Speaker Unit
2 x 10" Ashdown Driver & Tweeter
Input Impedance
1 Meg ohm
Input Signal Range 100Mv to 10v
E.Q.
Bass, Hi-Mid, Lo-Mid, Treble & Variable Mid Sweep
Ashdown Amplifiers reserve the right to change specifications without notice. E & O E. All contents © Ashdown 2016.
Advertisement
