Seat Belts - Opel 2016 Combo Owner's Manual

42 Seats, restraints
2. Push the lower lever to disengage
the locks and remove the seat
assembly from the floor anchor
points.
3. Store head restraints on the rear
of the seat frame.
Installing the seats
1. Attach the seat assembly front
supports to the front anchor
points.
2. Lower the rear of the seat
assembly to the floor, ensuring
the rear support is located on the
anchor point.
3. Push the lower lever and pull it to
ensure the locks are engaged and
the seat assembly is locked
securely in position.
4. Remove head restraints from the
rear of the seat frame, then raise
the backrest and replace the head
restraints.
Note
The backrest is properly engaged
when the red mark on the release
lever is no longer visible.
9 Warning
When installing the rear seats,
ensure that the seat assembly is
properly located on the anchor
points, the locks are fully engaged,
and the backrest is returned to the
correct position.
Failure to do so may result in
personal injury in the event of hard
braking or a collision.

Seat belts

The seat belts are locked during
heavy acceleration or deceleration of
the vehicle holding the occupants in
the sitting position. Therefore the risk
of injury is considerably reduced.
9 Warning
Fasten seat belt before each trip.
In the event of an accident, people
not wearing seat belts endanger
their fellow occupants and
themselves.