Engine Coolant Temperature; Preheating; Diesel Particle Filter - Opel 2016 Combo Owner's Manual

82 Instruments and controls
Illuminates during driving
A fault in the system is present.
Continued driving is possible. Driving
stability, however, may deteriorate
depending on road surface
conditions.
Have the cause of the fault remedied
by a workshop.
Depending on version, a warning
message may also be displayed in
the Driver Information Centre (DIC)
3 86.
Electronic Stability Control (ESC)
3 122, Traction control system/Anti-
Slip Regulator (ASR) 3 122.

Engine coolant temperature

$ illuminates red.
Illuminates for a few seconds after the
ignition is switched on.
If control indicator $ illuminates, the
coolant temperature is too high.
Depending on version, a warning
message may also be displayed in
the Driver Information Centre (DIC)
3 86. Seek the assistance of a
workshop.
Caution
If engine coolant temperature is
too high, stop vehicle, switch off
the ignition. Danger to engine.
Check coolant level.
If the control indicator remains on,
seek the assistance of your
workshop.
Engine coolant temperature gauge
3 73.

Preheating

! illuminates yellow.
Preheating is activated. Only
activates when outside temperature
is low.
Note
In very hot outside
temperatures, ! may illuminate
briefly when the ignition is switched
on.
The engine can be started when !
extinguishes.
Starting the engine 3 110.
Flashes
A fault is detected in the engine
preheating system. Depending on
version, a warning message may also
be displayed in the Driver Information
Centre (DIC) 3 86.
If ! does not extinguish, consult a
workshop.

Diesel particle filter

% illuminates yellow.
Illuminates for a few seconds after the
ignition is switched on.
If it does not extinguish after a brief
delay or illuminates whilst driving, the
diesel particle filter requires cleaning.
Continue driving until %
extinguishes. Depending on version,
a warning message may also be
displayed in the Driver Information
Centre (DIC) 3 86.
If possible, do not allow engine speed
to drop below 2000 rpm during the
cleaning process.