Indicators - Mitsubishi Electric XD110U SD110U User Manual

Indicators

This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your dealer.
STATUS indicator
Normal condition
POWER STATUS
Steady red Off
Steady green Blinking green
Steady green Steady green
Abnormal condition
POWER STATUS
Steady green
or
Blinking orange
Steady red
Steady red Blinking green
Steady green Blinking green/red
Steady red Blinking red
Steady red Steady red
Blinking green/red Off
Steady
or
Blinking green/red
Blinking
EN-26
CONDITION
Stand-by
Lamp stand-by (about 1 minute)
The power is on. (Normal condition)
CONDITION
Abnormal temperature
• The ventilation grilles is clogged with dust or dirt.
• The room temperature is high.
The protection circuit is working or the lamp is in an
abnormal condition.
The lamp operation time exceeds the time elapsed until
the lamp shutdown notice while the power is on. (See
page 22.)
The lamp operation time exceeds the time elapsed until
the lamp shutdown notice while the power is off. (See
page 22.)
The lamp operation time exceeds the time elapsed until
the lamp shutdown. (See page 22.)
The lamp cover isn't closed.
Abnormal.
POWER indicator
NOTE
The POWER button cannot be used to switch
between on and off.
POSSIBLE SOLUTION
• Clean the ventilation grilles.
• Relocate the projector to a cooler place.
• Wait until the STATUS indicator goes out,
then press the POWER button.
• If the above solution is not effective,
replace the lamp.
Replace the lamp.
Change with a new lamp if this problem
recurs.
Close the cover correctly.
Contact your dealer.