Mitsubishi Electric XD110U SD110U User Manual page 16

Menu operation (continued)
1 IMAGE
CONTRAST.................................Use to adjust the image contrast. The contrast
BRIGHTNESS .............................Use to adjust the image brightness. The image
WHITE ENHANCE ......................Use to adjust the white level of the projected image.
COLOR TEMP.............................Use to adjust the color temperature. See page 18.
COLOR........................................Use to adjust the color intensity of the image.
TINT.............................................Use to adjust the color balance of the image. The
SHARPNESS ..............................Use to adjust the image sharpness. The image becomes sharp as the value increases. (Not
GAMMA MODE ..........................When AUTO is selected, the appropriate gamma mode is automatically selected depending on
2 INSTALLATION
AUTO POWER ON ......................When ON is chosen, the lamp is automatically lit
AUTO POWER OFF ....................Use to set the time elapsed before the projector
SPLASH SCREEN ......................Choose ON to display the splash screen when the
BACK COLOR .............................Use to select the background from among BLUE and BLACK, which will be displayed when there
LAMP MODE ...............................Use to change the brightness of the lamp. When LOW is chosen, the lamp brightness is kept low
IMAGE REVERSE .......................Use to reverse the projected image. Select MIRROR for rear projection with the tabletop-
EN-16
becomes higher as the value increases.
becomes brighter as the value increases.
Select AUTO for normal use.
color balance shifts to green as the value increases
and shifts to purple as the value decreases. (Avail-
able only when VIDEO or S-VIDEO is chosen as the
source.)
• When the TV50 (PAL, SECAM) signal is input, TINT can't be adjusted.
available with certain signals.)
the input signal. For normal use, select AUTO. Select DYNAMIC for computer sources. Select
STANDARD for sport scenes and video sources. Select THEATER for film sources.
when the power cord is plugged in the wall outlet.
Choose ON when using the projector mounted on the
ceiling.
• The projector is in the stand-by mode when the
lamp is off. Use the remote control to turn on the
lamp.
enters the stand-by mode when there is no signal
input from the source.
power is turned on.
is no signal input from the source.
and the projector operating noise is reduced, resulting in a longer lamp replacement interval.
• When the lamp mode is switched, the projected image may flicker. This is not a product mal-
function.
• Do not change the setting of LAMP MODE frequently.
• When LAMP MODE has been set to LOW, the lamp mode changes from STANDARD to LOW
about one minute after turn-on.
mounted projector. Select MIRROR INVERT for front projection with the ceiling-mounted projec-
tor.
opt.
XGA60
IMAGE
CONTRAST
BRIGHTNESS
WHITE ENHANCE AUTO
COLOR TEMP. STANDARD
COLOR
TINT
SHARPNESS
GAMMA MODE AUTO
opt.
XGA60
INSTALLATION
AUTO POWER
ON
AUTO POWER
OFF
SPLASH
ON
SCREEN
BACK COLOR BLUE
LAMP MODE STANDARD
IMAGE
REVERSE
0
0
0
0
0
OFF
OFF
ON
OFF