Table of Contents
Advertisement
2-12 Blower Cone Installation
Fasten the Blower Cone P#(V0016) to the blower
housing located on the PTO assembly P#(A1132). Use
(3) 1/4"-20 x 1/2"HHCS P#(K1105), (3) 1/4" Lock
Washers P#(K0039), and (3) 1/4" Flat Washers
P#(K0037) to secure the blower cone to the blower
housing. Refer to Figure 2-12 for reference.
Figure 2-12
1/4"-20 x ½"
HHCS
1/4" Lock
Washer
2-13 Boot To Mower Deck Installation
NOTE: The boot kit assembly is designed to fit the 48"
and 60" deck. To ensure a snug fit between the boot and
the mower deck, follow the instructions in this step
thoroughly, and remove and tighten all hardware in the
sequence specified.
Loosen (DO NOT REMOVE) the deflector hardware
shown in Figure 2-13a.
Figure 2-13a
Blower
Housing
Blower
Cone
1/4" Flat
Washer
Loosen Hardware
Deflector
Locate the deck mount plate P#(A1120). Lift the
deflector and position the deck plate as shown in Figure
2-13b.
Lift Deflector
Deck Mount
Plate
Insert the front portion of the deck mount plate between
the deflector mount bracket and the mower deck. Align
the front slot of the deck mount plate with the front set of
hardware on the deflector. Slide the deck mount plate to
the forwardmost position and insert the rear portion of
the deck mount plate between the deflector mount plate
and the mower deck. Align the rear slot in the deck
mount plate with the rear set of hardware on the
deflector. Refer to Figure 2-13c.
Deflector
Mount Plate
Mower
Deck
Adjust the deck mount plate forwards/backwards so the
both sets of hardware are inside the slots on the deck
mount plate as shown in Figure 2-13d.
9
Figure 2-13b
Figure 2-13c
Deck Mount
Plate
Figure 2-13d
Align Slots
With Hardware
Advertisement
Table of Contents
