ICS 695GC Operator's Manual page 16

OPERATION
FUEL MIXING
• Always mix gasoline and oil in a clean container intended for use
with fuel.
• Keep fuel container closed tightly to prevent moisture from getting
into the fuel.
• Always begin mixing fuel by adding half the amount of gasoline to
be used. Then add the correct amount of 2-stroke oil for 50:1 (2%)
mixture and finish filling the container with gasoline.
• Do not mix more than one month's supply of fuel. This helps prevent
the separation of the 2-stroke oil from the gasoline (varnishing).
• If the saw is not used for an extended period of time (3 months) the
fuel tank should be emptied and cleaned.
FUELING
• Always shut off the saw before fueling.
• Before fueling, clean the area around fuel cap to prevent dirt from
contaminating the fuel. Contamination of the fuel tank can lead to
saw malfunction.
• Thoroughly mix the fuel in it's container before fueling.
• Slowly open the fuel cap to release any pressure that may have
built-up in the tank.
• After adding fuel, carefully install the fuel cap and tighten firmly
by hand.
16
© 2015 ICS, Blount International Inc. Specifications are subject to change
without notice. REV010515 F/N 545067