After Operation - Yanmar EF393T Operator's Manual

AFTER OPERATION

1. After operation
Clean thoroughly the tractor after daily operation to keep it in
good condition for a long time. In particular, clean lower and
front areas before storing it.
Wash the tractor with water and wipe off. Lubricate moving
parts and sliding parts. Apply grease to all grease nipples
especially after working in wet field.
IMPORTANT
spray water on electrical parts. Water can
Do not splash or
cause a trouble in the electrical system.
2. Care for long period of storage
WARNING
When tractor is stored for a long time, remove the battery and
main key. Deterioration of electric wire or rat biting may
cause electric leakage and may start a fire.
When storing for a long time, take following procedures.
(1) Turn off all switches and remove the main switch key.
(2) Place the tractor in a well ventilated place and remove
counterbalance weights or other implements.
(3) Coat exposed metallic parts with anti-rusting oils, engine
oils or greases.
(4) Fill up the fuel tank with fuel. Otherwise, moisture will
develop in the tank and cause rust. Close cock of water
separator and fuel filter.
(5) Charge the battery fully. Remove the battery from the
tractor and keep it in a dark and cool place. If the battery
is kept on the tractor, be sure to disconnect the ground line
(negative lead).
(6) Drain coolant from the engine.
Move the hose clip and pull out the drain plug.
IMPORTANT
The battery is subject to self-discharge.
Charge it fully at least once a month.
(A) Coolant drain plug
(B) Hose clip
47
EF393T OM