Hydraulic Power Take Off; Using 3-Point Hitch - Yanmar EF393T Operator's Manual

13. Hydraulic power take off

Single action cylinder
In case of single action cylinder, remove the
hydraulic outlet plug (A) on right side of control valve,
and connect hydraulic hose from cylinder of
implement.
<Operation>
(1) Set the position control lever in the lower position.
(2) Fasten the hydraulic stop/slow return valve (B) at
fully clockwise position.
(3) Operate the position control lever to move the
implement.
Double action cylinder
<Connection>
(1) Remove operator's seat.
(2) Remove the dust cover under the seat.
(3) Remove the high pressure pipe (E).
(4) Connect hydraulic hose to port (C) that the oil goes
to SCV and connect hose to port (D) that oil comes
back from SCV.
(5) Install the dust cover and the seat.
Keep the high pressure pipe for the time when
removing SCV.

14. Using 3-point hitch

3-point rear hitch type is Category 1.
Top link
Adjust length of top link (A) to implement. Loosen
lock nut turn turnbuckle on top link and adjust the
length.
Follow instructions of implements.
(A) Hydraulic outlet (single action) (G3/8)
(B) Hydraulic stop/slow return valve
(C) Hydraulic outlet (double action, out) (G3/8)
(D) Hydraulic outlet (double action, in) (G3/8)
(E) High pressure pipe
(F) Relief valve
(G) Hydraulic control valve
(A) Top link
(BR) Lift link, Right
(D) Lower link
42
(BL) Lift link, Left
(C) Check chain
EF393T OM