Fault.indications.wm60.2 - Asko WM60 Service Manual

Fault indications WM60.2
Error messages
Close t��e door The.door.was.not.closed..
•.Too.much.water.in.the.machine
Over flo� fault •.The.drain.pump.is.on,.without.
any.water.in.the.machine.
•.The.drain.pump.has.been.
activated.more.than.3.
minutes..There.is.still.water.in.
the.machine.
•.The.wash.cycle.is.interrupted.
and.the.program.is.cleared
Outlet fault
•.If.the.correct.water.level.is.not.
reached.within.5.minutes,.the.
wash.cycle.is.interrupted.
Water inlet fault
Indicated.if.the.tacho.generator.
is.overloaded.or.control.signal.is.
Motor fault
missing.(from.the.tacho.generator.
or.MCU).
Cause Action
Close.the.door
•.Check.the.machine's.level.system,.inlet.valve.and.drain.pump..Make.
sure.that.there.is.no.leaks.
•.The.overflow.protection.at.the.bottom.of.the.machine.is.activated.(not.
all.models)..Make.sure.that.there.is.no.leaks.(water.on.the.machines.
base)
Customer information:
1.. Check.that.no.objects.are.stuck.in.the.drainage.hose.outlet.
2.. Check.that.the.drain.pump.is.not.blocked.by.foreign.objects.
3.. Check.that.there.are.no.kinks.in.the.drainage.hose.
Service action:
1.. If.the.pump.only.runs.for.a.short.while.(approximately.20.seconds),.
this.indicates.a.fault.in.the.level.system..Check.the.level.sensor.and.
hoses.
2.. Check.wiring.and.voltage.to.the.pump..If.necessary,.replace.the.pump.
and/or.control
3.. After.implementing.corrective.action,.run.the.Drain.program.or.press.
the.Key.button.(door.open).to.empty.the.machine.
Customer information:
1.. Check.that.the.tap.on.the.water.pipe.is.open.
Service action:
1.. Check.that.the.filter.in.the.machine's.water.intake.is.not.blocked.
2.. Check.the.inlet.valve..If.necessary,.replace.the.valve.
3.. Check.voltage.to.the.inlet.valve..If.there.is.no.voltage,.this.could.be.
due.to.a.fault.in.the.level.system,.wiring.or.control.unit.
Check.signal.from.the.MCU.and.cables.between.motor.and.MCU.
Service.manual.WM60
27