Advertisement
r2.0-7/8/14
INSTALLATION INSTRUCTIONS
1. Remove the PowerAire® unit from the factory packaging. Take care to check that each required separate
component is in the shipping packaging as listed below, and figure 1 for details.
A. 1 x PowerAire Fan Assist Device
B. 1 x Three Point Color Coded Temperature Sensor Tree(Quad- M only)
C. 1 x single Point Temperature sensor Tree (Quad-S only)
D. 10 x Temperature Sensor Tree Zip Ties (Quad-S and M only)
E. 4 x Tool Less Roll Formed Stringer Hangers
F. 1 x PowerAire® power cord
Not Pictured: The PowerAire® Quad is designed for optimum use with Tate's DirectAire® airflow panel
ordered separately; other airflow panels may reduce the performance of the PowerAire® Quad.
2. Remove the existing airflow panel, and installed the four Tool Less Roll Formed Stringer Hangers into the
stringer system. The hangers should be oriented with the larger angled bottom hook facing into the center of
the removed panel. Simply orient the hanger at a 45 degree angle with the floor, sliding hanger's smaller
angled hook surface into the gap in the roll formed stringer's bottom surface, and then allow the hanger to
roll back perpendicular to the floor surface. Repeat this for all four sides of the panel. See figures 2-4 below.
7510 Montevideo Road
Jessup, MD 20794
Tel (410)799-4200
Installation Guide: PowerAire® Quad
Quad- S: 16943, 17351 Quad- M: 16886, 16633 Quad- C: 17347, 17348
Figure 1 - Illustrated Parts List
© 2012 Tate Access Floors, Inc.
3 of 15
Advertisement
