Advertisement
r2.0-7/8/14
13. The user should now set the desired supply air temperature that should not be exceeded at the IT rack
intake. The menu of the controller is accessed as follows.
A. Pressing the SET button and hold it for approximately 2 seconds will display the value ST1, and then
show the set point in flashing characters. Simply use the up and down buttons to adjust the set point.
Press set once more and the new set point value will be stored.
Figure 20 - Installation of DirectAire
7510 Montevideo Road
Jessup, MD 20794
Tel (410)799-4200
Installation Guide: PowerAire® Quad
Quad- S: 16943, 17351 Quad- M: 16886, 16633 Quad- C: 17347, 17348
Figure 19 - Scrolling Through Temperature Value
®
Panel
Figure 21 - Typical Operation
© 2012 Tate Access Floors, Inc.
12 of 15
Advertisement
