To Activate; To Turn Off; Time Programming Function; Turning Off A Hotplate Automatically - Siemens EH6..MV1.. series Instruction Manual

To activate

Select the power level
Š
1.
Press the programming panel located above the
2.
The function has been activated.

Time programming function

This function may be used in two different ways:
to automatically switch off a hotplate.
■
as a timer.
■

Turning off a hotplate automatically

Enter the cooking time for the required hotplate. The hotplate
turns off automatically once the time has elapsed.
How to program
Select the required power level.
1.
Press the symbol. The
0
2.
up. is displayed on the time program function display. To
‹‹
select another hotplate, press the
until the indicator for the desired hotplate lights up.
x

Select the required cooking time in the programming panel.
3.
The possible previous setting is, from left to right 1, 2, 3, etc.,
up to 10 minutes. Within the next 10 seconds, continue
passing through the options on the programming panel until
reaching the desired time.
After a few seconds, the cooking time begins to count down.
Automatic programming
If the previous setting from 1 to 5 is pressed in the
programming panel, the cooking time is reduced by one
minute, if it is held down the time is automatically reduced to
one minute.
If the previous setting from 6 to 10 is pressed in the
programming panel , the cooking time is increased by one
minute, if it is held down the time is automatically increased to
99 minutes.
Once the time has elapsed
The hotplate switches off. An audible signal sounds and
appears in the time program function display for 10 seconds.
The indicator lights up. Pressing the
x
indicators and stops the signal.
10
.
@›
indicator on the hotplate lights
x
symbol several times
0

symbol turns off the
0

To turn off

Press the programming panel located above the
The Powerboost function has been deactivated.
symbol.
Note: In certain circumstances, the Powerboost function may
turn off automatically in order to protect the electronic
components inside the hob.
Changing or cancelling the time
Press the
0
indicator lights up. Change the cooking time in the
programming panel, or set to
Notes
If a cooking time has been programmed in several zones, it
■
can be set to display all time values. To do this, press the
symbol several times until the
hotplate lights up.
Cooking times of up to 99 minutes can be programmed.
■

Automatic timer

With this function you may select a cooking time for all
hotplates. Once a hotplate is switched on, the selected time will
begin to count down. The hotplate will automatically switch off
when the cooking time has elapsed.
Instructions on activating the timer are found in the chapter
entitled "Basic settings".
Note: The cooking time of a zone may be cancelled or
changed:
Press the 0
indicator lights up. Change the cooking time in the
programming panel, or set to

The timer

The timer can be set for periods of up to 99 minutes. It is
independent of the other settings. This function does not
automatically switch off a hotplate.
Programming
Press the
0
1.
up. ‹‹ lights up in the time program function display.
Select the desired time in the programming panel.
2.
The timer starts to count down after a few seconds.
Once the time has elapsed
A warning beep sounds. In the time program function display
is shown, and the
‹‹
the indicators turn off.
Pressing the
beep.
Changing or cancelling the time
Press the 0
‹‹
up. Change the cooking time in the programming panel, or set
to .
‹‹
symbol several times until the required
.
‹‹
indicator for the required
x
symbol several times until the required
.
‹‹
symbol several times until the
indicator comes on. After 10 seconds
W
symbol turns off the indicators and stops the
0
symbol several times until the
@› symbol.
x
0
x
indicator lights
W
W indicator lights