Sound Projector - Mitsubishi 738 Basic Owner's Manual

18 3. TV Features
838 Series
The TV's built-in speaker array can be set up to reflect
sound off the room walls to create a surround sound effect.
Positioning the TV
o Center the seating area in front of the TV and at
Beast six feet away.
Arrangements that give good resuBts:
Rfthe room is an odd shape, )ocate the TV to take
best advantage of waU reflections.
Avoid )ocations that may distort sound reflections.
U
3_
4.
PBacethe microphone as described in the guide-
Unes.
Press MENUand go to Sound > AutoSP,
HighUght START and press ENTER.
6, Quietly exit the room right away. The caUbration
sequence may be )oud. Wait for completion of setup
before returning to the room.
7, PBaysome sampBe audio materia) to check the
sound quaUty.
Note: Do not perform manua) adjustments after run-
ning auto setup as doing so wiU deBete aUauto-
setup results.
8, Store the microphone out of direct sunlight and
away from heat.
Connecting the TV
To hear digital surround sound, the TV must be con-
nected to a digital surround sound source. The surround
sound source can be on an HDMI input or the ANT input
(for some digital broadcasts). Other stereo connections
will provide Dolby Pro Logic surround sound.
Auto Setup
Auto setup uses the included calibration micro-
phone. For manual setup, see the full owner's guide at
www.mitsubishi-tv.com.
1, Power on the TV and external subwoofer, if any.
Plug the microphone cable into the TV's mNPUT 3
left audio jack.
For assistance ca((1(800} 332-2119