Chapter 9 Troubleshooting; Bios Error Beep Codes; Non-Fatal Errors; Fatal Errors - Imagine Nexio AMP NX3801 HDI Gen6 Hardware Installation And User's Manual

9
This chapter provides information about BIOS error beep codes, power supply modules and drive failures.

BIOS Error Beep Codes

During the POST (Power-On Self-Test) routines, which are performed each time the system is powered on,
errors may occur.

Non-fatal errors

Are those which, in most cases, allow the system to continue the boot-up process. The error messages
normally appear on the screen.

Fatal errors

Are those which will not allow the system to continue the boot-up procedure. If a fatal error occurs, you
should consult with BCD Technical Support. Refer to the
page 2.
These fatal errors are usually communicated through a series of audible beeps found in
numbers on the fatal error list correspond to the number of beeps for the corresponding error.
Table 9-1. BIOS Error Beep Codes
Beep Code
1 beep
5 short beeps and 1 long beep
5 beeps
1 Continuous beep
Troubleshooting
Error Message
Refresh
Memory error
No Con-In or Con-Out
devices
System OH
Regional Service Contact Information
Description
Circuits have been reset (Ready to power up)
No memory detected in the system
Control-in includes:
USB or PS/2 keyboard

PCI or Serial console redirection

IPMI KVM or SOL

Control-out includes:
video controller

PCI or Serial console redirection

IPMI SOL.

Regional Service
System Overheat. Refer to
Contact Information
on page 2.
73
on
Table 9-1. The