Setting Date And Time - HIKVISION DS-8100-S Series Quick Operation Manual

DS-8100HCI-ST Series DVR Quick Operation Guide
15. To access Record Settings interface, click the Enter button.
16. Select the Schedule tab.
17. Click Edit button to enter a new recording schedule.
18. Check both the Enable Schedule and All Day checkbox. This will enable the recording schedule and
make it record continuously all day.
19. Click the OK button. This will take you back to the Schedule tab. To copy the schedule to a different channel,
select the channel or all under Copy To and click the Copy button.
20. Click Next button to access the Network Settings dialog box.
21. To configure network settings, click the Enter button.
22. Enter the IP Address, Subnet Mask and Default Gateway settings.
23. Click OK button to return to the Setup Wizard.
24. If all the settings have been entered, click Done to finish and exit the Setup Wizard.
Setting Date & Time
It is extremely important to setup the system date and time to
accurately timestamp recordings and events.
To set date and time:
1. Enter General Settings menu by clicking Menu>
Settings > General.
2. Enter the correct date and time under System Time.
3. Click the Apply button to save the setting.
36