Maintenance Procedure - SYMA X5SW Instruction Manual

WIFI install camera
Disassembly steps of camera:
1. Pull out power supply cable of the
camera as shown in Figure (1).
2. Press safe lock of lower main body
forcibly and pull back the camera
simultaneously.
Installation steps of camera:
1. Push the camera in place as
shown in Figure (1).
2. Connect connecting line of camera
with power supply socket of
fuselage's camera as shown in
Figure (2).

Maintenance procedure

Problems
1. Aircraft enters into low-voltage
protection.
2. Electric quantity of remote control is
Aircraft has
insufficient, power indicator light will
no response
flicker.
3. Channel selection of remote control
is inconsistent with aircraft's match
codes.
1. Insufficient remote control's electric
Aircraft's flying
quantity.
response is
2. Remote control with the same
insensitive
frequency is transmitting interference.
When hovering,
1. Have no horizontal correction.
side flight is
formed
In headless
1. Head deflection is caused by
state,
multiple collisions.
it deviates
to dead ahead
Causes
-12-
Figure 1
Figure 1
Solutions
1. Charge the aircraft.
2. Change remote control's battery.
3. Adjust channels of remote control
and aircraft, and make them become
consistent.
1. Battery replacement.
2. Change the place where has no
transmitting interference of the
same frequency.
1. Conduct horizontal correction, as
shown in p.9(3)(correcting function)
1. Define forward again, as shown in
p.9-10(6)(headless function)
Figure 2
Figure 2