SYMA X5SW Instruction Manual page 11

Front
Left
Read
2. Switch to headless function and general function
1. After frequency modulation, the aircraft defaults
to general pattern. The indicator light on aircraft
is long bright state. After pressing down headless
function switch on the top left of master remote
controller for 2 seconds, remote control will give
out "DDD...", it means that it enters into headless
state. After pressing for 2 seconds and hearing long "D", it means that it
exits headless state.(In headless mode, four indicators on the aircraft
flicker slowly for once within four seconds)
2. In headless state, the operator has no need to
recognize the position of aircraft's headpiece,
and he just needs to control the aircraft in
accordance with the direction of remote control's
operating rod.
3. Correcting forward direction
1. After aircraft crashes in headless state, if there is
deviation in head direction, it just needs to adjust
the aircraft's direction again, pull remote control's
accelerator and operating rod to bottom left
simultaneously. When indicator light on the
aircraft flickers for slow three seconds,it means
that correction is done.
2. After aircraft connects with power supply, place
the switch in "ON" position, adjust the direction
pointed by aircraft's handpiece and regard it as
Right
the dead ahead in headless situation.
3. Push the accelerator's push rod of remote
control to the highest point and pull back to the
lowest point.
When remote control pops, it indicates that
frequency modulation and forward definition have
already finished.
-10-
右面
Front
Front
Left Right
Left Right
Read
Read