Precautions; When Moving This Unit; Installation Location; Regular Care And Maintenance - Pioneer u-05-s Operating Instructions Manual

Usb
Hide thumbs Also See for u-05-s:
Table of Contents

Advertisement

Additional information

Precautions

When moving this unit

When moving this unit, be sure to press the  STANDBY/
ON button on either the remote control or the main unit's
front panel to turn off the power. After confirming that the
front-panel power indicator has gone out, disconnect the
power cord.
After disconnecting the power cord, continue by
disconnecting all connected components and devices.
Attempting to move the unit with cords still attached to the
connectors can result in accidental damage.

Installation location

• Choose a stable location close to the other devices that
will be used with the unit.
• Avoid the following kinds of places:
- Locations exposed to direct sunlight
- Locations with high humidity or poor ventilation
- Locations susceptible to direct contact with water
- Locations exposed to extreme heat or cold
- Locations exposed to vibration
- Locations exposed to much dust
- Locations exposed to oily smoke, steam, or heat (e.g.,
kitchens)
Do not place other objects on top of the unit
Do not place other objects on top of the unit.
Do not allow heat to collect in the unit
Do not use the unit when placed on a long-pile carpet, bed,
or sofa, nor when wrapped in cloths, etc. Such conditions
can contribute to the excessive concentration of heat in the
unit, leading to malfunctions or damage.
Avoid heat
Do not install this unit on top of an amplifier or other heat-
emitting device. When installing the unit in a rack, install
the unit on a shelf lower than amplifiers, to avoid adverse
influences from the amplifier(s) heat.

Regular care and maintenance

• Dust the unit occasionally with a soft dry cloth. If
required for severe soiling, soak a cleaning rag in a 1:6
mixture of mild detergent and water, then wring the rag
well and wipe the unit clean. Afterwards, be sure to dry
any moisture on the unit with a soft, dry cloth.
• Do not use alcohol, thinner, benzene, insecticide or other
volatile compounds to clean the unit, since imprinting or
coatings may peel from the unit. The cabinet may also
be discolored or damaged from long exposure to rubber
or vinyl products.
• Before wiping the unit with any chemical-impregnated
cleaning cloths, carefully read the cautionary notices
accompanying the cloth.
• Always unplug the power cord from its outlet before
cleaning the unit.
Specifi cations
Line output
Output Level
RCA jack ................................................................. 2.4 V
XLR jack .................................................................. 4.4 V
Output impedance.................................................... 100 Ω
Frequency response ...................4 Hz to 100 kHz (−3 dB)
THD+N
RCA jack .......................................................... 0.0012 %
XLR jack ........................................................... 0.0007 %
S/N ratio (A-weight)
RCA jack ..............................................................114 dB
XLR jack ...............................................................117 dB
Dynamic range
16 bit .......................................................................96 dB
24 bit, 32 bit .........................................................118 dB
Headphones output
Output
STD jack ..............................180 mW + 180 mW (32 Ω)
XLR jack ..............................300 mW + 300 mW (32 Ω)
Supported impedance ................................. 16 Ω to 600 Ω
Frequency respose........................4 Hz to 80 kHz (−3 dB)
THD+N (output power −3 dB)
STD jack ............................................................... 0.01 %
XLR jack ............................................................. 0.004 %
Digital input
Input impedance
COAXIAL ................................................................. 75 Ω
AES/EBU ............................................................... 110 Ω
USB connector .................. USB2.0 compliant (type B)
Miscellaneous
Power requirements .............. 220 V to 230 V, 50 Hz/60 Hz
Power consumption ...................................................35 W
Power consumption (standby mode) .....................0.27 W
External dimensions (W x H x L)
..............................................296 mm x 101 mm x 271 mm
Weight ....................................................................... 6.3 kg
Accessories
Remote control ...................................................................... 1
Type AAA manganese batteries ........................................... 2
Power cord
CD-ROM (Operating Instructions)
Quick start guide
Safety Brochure
Warranty card
Note
• These specifications and appearance recorded here may
be changed without notice.
• Corporate and product names listed here are the
trademarks or registered trademarks of their respective
owners.
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents