To Return Settings To Factory Defaults; Using The Usb Dac Function; Install The Driver; Playing Music Files Located On A Computer - Pioneer u-05-s Operating Instructions Manual

Operation

To return settings to factory defaults

Perform this operation to return the unit's settings
to factory default values.
1 With the unit in STANDBY mode, hold the
remote control's Up Sample button depressed
and then press the main unit's front-panel /I
STANDBY/ON.
R E S E T ?
2 Press the remote control's DIRECT button.
The display will ask for final confirmation.
R E S E T ?
O K ?
3 To confi rm the reset operation, press the
remote control's DIGI FILTER button. All
settings will be returned to their factory
default values.
O K !

Using the USB DAC function

Install the driver

• Music files located on a computer can be played
by this unit through a USB connection between
the computer and this unit. In order to play files in
this way, however, a special driver may need to be
installed on your computer. For more information,
please consult the Pioneer website, where you
can find instructions regarding driver installation
and computer settings.
Playing music fi les located on a
computer
By using a USB cable to connect this unit to your
computer, the computer's audio playback software
can be used to play the computer's music files
through this unit.
Playing music fi les located on a computer
1 Use a USB cable to connect this unit to your
computer.
2 Turn on power to the computer.
3 Turn on power to this unit.
4 Select the proper output connector.
Rotate the front panel OUTPUT knob to select the
output.
When the output is from the analog output connector,
select LINE.
5 Set the input selector to USB.
Rotate the unit's front-panel INPUT knob, or press the
remote control's USB button.
6 Play the desired music fi le located on the
computer.
Note
• When using a USB connection from a computer to this
unit for playing music, the following signal formats can
be input to this unit from the computer:
Linear PCM
- Quantization bits: 16 bit, 24 bit, 32 bit
- Sampling rate: 44.1 kHz, 48 kHz, 88.2 kHz, 96 kHz,
176.4 kHz, 192 kHz, 352.8 kHz, 384 kHz
DSD
- Sampling rate: 2.8 MHz, 5.6 MHz
• Before disconnecting the USB cable, always be sure to
stop the computer's playback first.
• If the computer's USB port does not conform to the USB
2.0 HS standard, playing music files may not be possible.
• When using a USB connection as described above, this
unit's playback function cannot be used to play music
files; playback must be performed with the computer's
own playback software.
11