Setting Up Procedure - Duplo DocuCutter CC-228 Operational Manual

SETTING UP PROCEDURE

To set the width of paper,
loosen thumbscrew knob
1 on the side guide and slide
to position. Use marking
as reference point.
Fan paper before loading.
This will reduce static and
toner adhesion due to
2
printing. For best result,
the paper stack should be
flat.
Push the feed tray down
and load the paper.
3
Readjust paper guide if
needed.
Adjust tray pressure. For
thinner paper, the number
4 should be higher. For
heavier paper the number
should be lower.
Thumbscrew knob
Paper feed guide
Page 11
Markings