Troy-Bilt 700 Series Operator's Manual page 19

5. Install the tine assemblies on the proper tine shaft using
the hex screw and flange lock nut as seen in Figure 7-6.
NOTE: Be sure the tines are installed on the proper side.
The tiller will not perform properly if installed incorrectly.
6. To remove and individual tine from the assembly, remove
the tine assembly as instructed above and remove the
individual tine be removing the hex screw and hex lock nut
that secure it to the assembly.
NOTE: Like the assemblies, there are specific tines for both
the RH (Part No. 742-05076) and LH (742-05091) assemblies.
Be certain the tine is the same as the others on the
assembly.
Change Transmission Gear Oil
NOTE: The transmission gear oil does not need to be changed
unless it has been contaminated with dirt, sand or metal particles.
See an authorized service dealer to have the transmission gear oil
changed. Refer to the phone numbers on page 2 of this manual
to locate the nearest service dealer.
S 7 — S 19
ection ervice