Operation - Troy-Bilt 700 Series Operator's Manual

Operation

Starting the Tiller
Pre-Start Checklist
With the spark plug wire disconnected from the spark plug,
make the following checks and perform the following services
before starting the engine.
1. Read the Safe Operation Practices and Controls & Features
Sections in this manual. Read the separate Engine Operator's
Manual.
2. Check the machine for loose or missing hardware. Service
as required.
3. Check the engine oil level. See Engine Operator's Manual.
4. Check that all the safety guards and covers are in place.
5. Check air cleaner. See Engine Operator's Manual.
6. Attach the spark plug wire to the spark plug.
7. Fill the fuel tank with gasoline according to the directions
in the separate Engine Operator's Manual. Follow all the
instructions and safety rules carefully.
WARNING!
Never run the engine indoors or in
enclosed, poorly ventilated areas. Engine exhaust
contains carbon monoxide, an odorless and deadly
gas. Avoid the engine muffler and nearby areas.
Temperatures in these areas may exceed 150° F.
Starting the Engine
1. Complete the "Pre-Start Checklist" above.
2. Disengage the tines.
3. Flip the power switch into the ON position,
4. Proceed with the engine starting instructions in your
Engine Operator's Manual.
Stopping the Tiller
1. To stop the wheels and tines, release the forward clutch
bail or the reverse handle (whichever control is engaged)
and place the neutral handle in the disengaged position.
2. To stop the engine place the power switch in the OFF position
and follow the instructions in your Engine Operator's Manual.
Setting the Depth
To set the tilling depth, remove the depth pin from the shield
height adjustment bracket and lift up on the handle. Place the
depth pin in the desired hole in front of the tine shield stop and
carefully lower the handle. See Figure 5-1.
Figure 5-1
NOTE: The depth pin is keyed and will need to be turned to
remove and install into the shield height adjustment bracket.
Engaging the Drive & Tines
1. For forward motion of the tines:
a. With the neutral handle in the free wheel position,
pull the clutch control bail up and hold it against the
handlebars. See Figure 5-2. To stop the forward motion
of the tines, release the bail.
Figure 5-2
5
11