Sand Loading - Intex Krystal Clear CS15110 Owner's Manual

SETUP INSTRUCTIONS (continued)

Sand loading:

IMPORTANT: Use only No. 20 silica sand with particle size range 0.45 to 0.85
mm (0.018 to 0.033 inches) and a Uniformity Coefficient less than 1.75.
NOTE: Before loading the tank with sand, ensure the center pipe hub
assembly is securely in place at the bottom of the tank, and vertically
centered inside the tank.
1. Place the sand shield (7) over the top of the center pipe. Pour the sand into the
tank at a slow rate.
2. Fill the tank approximately half way, remove the sand shield
drawing 16).
7
3. Evenly distribute the sand inside the tank, then fill the tank with some water to
provide a cushioning effect when the remaining sand is poured in. This
prevents the center pipe hub
Place the sand shield
4. Sand shall be filled between the "MAX" and "MIN" marked gauge on the center
pipe. Evenly spread and level out the sand by hand (see drawings
5. Remove the sand shield
6. Wash away all sand around the top edge of the tank.
SAVE THESE INSTRUCTIONS
(163) MODEL CS15110 SAND FILTER PUMP & FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U
(see drawing 15).
15
(8) from excessive shock
(7) back and continue to pour the sand into the tank.
17
8
MAX
MIN
(7).
English
(7). (see
7
(see drawing 17).
17 & 18).
8
MAX MAX
MIN MIN
MAX
MIN
09/18/2010
163
16
18
Page 13