Installing The Ftc Unit - Mitsubishi Electric PUHZ-W50 Installation Manual

2. Installing the FTC unit

Fig. 2-1
B
Photo.2-1
336
11.5 313
TB142
3-ELECTRIC WIRE INLET
When installed on a wall: Lower side
Fig.2-2
TEMP.
ON/OFF
A
(11.5)
TB6
TB141
2.1. Check the parts (Fig. 2-1)
The FTC unit should be supplied with the following parts.
Part Name
1
FTC unit
2
Thermistor
3 Remote controller cable(5m)
4 Remote controller
2.2. Choosing the FTC unit installation location
• Do not install the FTC unit in outdoor location as it is designed for in-
door installation only. (It is not waterproof against raindrop.)
• Avoid locations where the unit is exposed to direct sunlight or other
sources of heat.
• Select a location where easy wiring access to the power source is
available.
• Avoid locations where combustible gases may leak, be produced,
fl ow, or accumulate.
• Select a level location that can bear the weight and vibration of the
unit.
• Avoid locations where the unit is exposed to oil, steam, or sulfuric gas.
• Do not install in location that is hot or humid for long periods of time.
2.3. Installing the FTC unit (Fig. 2-2, Photo.2-1)
1. Remove 2 screws from FTC unit and remove the cover.
2. Install the 4 screws (locally supplied) in 4 holes.
A Screw B Cover
C Hole for installation
Unit:mm
69
Q'ty
1
2
1
1
3