Electrical Work - Mitsubishi Electric PUHZ-W50 Installation Manual

4. Electrical work

C
Photo.4-1
A
4.1.1. FTC unit power supplied from outdoor unit
The following connection patterns are available.
The outdoor unit must be powered properly.(Details are shown in its installation manual.)
D
A B C
N
S1
S2
S3
Photo.4-2
FTC unit model
FTC unit-Outdoor unit
FTC unit-Outdoor unit earth
FTC unit-Outdoor unit S1-S2
FTC unit-Outdoor unit S2-S3
*1. Max. 80 m
*2. The fi gures are NOT always against the ground.
S3 terminal has DC 24 V against S2 terminal. However between S3 and S1, these terminals are not electrically insulated by the transformer or other device.
Notes: 1. Wiring size must comply with the applicable local and national codes.
2. Power supply cables and FTC unit/outdoor unit connecting cables shall not be lighter than polychloroprene sheathed fl exible ca-
ble. (Design 60245 IEC 57)
3. Install an earth wire longer than other cables.
6
C
B
E
F
L
S1
S2
S3
E
*1
*1
*2
*2
4.1. FTC (Photo. 4-1)
1. Remove the cover.
2. Wire the power cable and control cable separately through the re-
spective wiring inlets given in the photo.
• Make sure to put screws tightly.
A Inlet for control cable
B Inlet for power
C Clamp
D FTC / Outdoor unit connecting terminals
E Earth terminal
D
A Outdoor unit power supply
B Earth leakage breaker
C Wiring circuit breaker or isolating switch
D Outdoor unit
E FTC unit/outdoor unit connecting cables
F FTC unit
TB6
L N
Earth cable
PAC-IF021B-E
3× 1.5 (polar)
1 × Min.1.5
AC 230 V
DC24 V
S1 S2 S3
E: FTC unit/outdoor unit
connecting cables