Advertisement
__________________________________________________________________________________________________________________________________________________________________________________________________
* Dialight is not responsible for damage to application surface or fixture, if mounted onto a surface that can not handle weight of fixture
MOUNTING BRACKET INSTALLATION STEPS:
1. Place [2] mounting pads on either end of the mounting bracket
•
Peel off adhesive backing from pad and adhere to mounting bracket as shown [Fig.1a]
2. Secure the mounting bracket onto application surface by means of hole pattern on mounting bracket [Fig.1b]
•
Feed source wire through center oval opening of mounting bracket [Fig.1c]
Fig.1a
LIGHT FIXTURE INSTALLATION STEPS:
1. Place light fixture on installed mounting bracket [Fig.3]
2. Install center pivoting 5/16 hex bolt on both sides of light fixture [Fig.4] _ [do not tighten]
3. Aim light fixture to desired angle [Fig.5]
4. Once desired angle is established, install angle locking 1/4 x 3/4 long hex bolt [Fig.6] _ [do not tighten]
5. Torque all installed bolts as follows:
5/16 center pivoting bolts [Fig.4] ............................................................................... suggested torque = 11.5 ft.lb. [15.6 Nm]
1/4 angle position bolts [Fig.6] ................................................................................... suggested torque = 6.5 ft.lb. [8.8 Nm]
Fig.3
1501 Route 34 South, Farmingdale, NJ 07727
Dialig
ht de México S.R.L de C.V. Calle Lirios s/n Col. Carlos Pacheco, Ensenada Baja California, México C.P. 22830
FLOODLIGHT - "FL" VIGILANT SERIES
INSTALLATION INSTRUCTIONS
IMPORTANT: Make sure application surface can handle weight of light fixture
Fig.4
Fig.1b
Fig.5
Tel: 732.919.3119
Fax: 732.751.5778
Document # 9100127242999 Rev.D / 33356
February 2016
Fig. 1c
_ repeat to other side
_ repeat to other side
Fig.6
www.dialight.com
+52 (646) 156-70-80
Page 2 of 4
Advertisement
