Dialight FL SERIES Installation Instructions

__________________________________________________________________________________________________________________________________________________________________________________________________
IMPORTANT: Please read carefully before installation and retain for future reference
To prevent possible shock hazard, the fixture should be installed by a qualified licensed electrician.
All electrical connections must be in accordance with local codes, ordinances and National Electrical Code.
The use of safety protection such as safety eye glasses and protective gloves are recommended
Proper grounding of the fixture is essential for protection from shock, correct operation and the elimination of electrical
interference.
DANGER: RISK OF ELECTRICAL SHOCK. TURN OFF MAIN POWER SOURCE BEFORE SERVICE
Always transport and store the equipment in its original packaging and keep in a dry location.
When unpacking check for any cracks or damage to casting and glass lens, if in doubt do not install!
Contact your local Dialight sales representative or visit us at
INSTALLATION STEPS:
* Dialight is not responsible for damage to application surface or fixture, if mounted onto a surface that can not handle weight of fixture
Securely mount lower mounting bracket to application surface
If installing other than 90°, loosen, but do not remove, pivoting bolts 6 .
Remove angle locking bolts 7 .
Pivot to desired angle, replace and tighten angle locking bolts 7 to 5 ft.lb. [6.8 N m]
Tighten pivoting bolts 6 to 25 ft.lb [33.9 N m]
1501 Route 34 South, Farmingdale, NJ 07727
Dialig
ht de México S.R.L de C.V. Calle Lirios s/n Col. Carlos Pacheco, Ensenada Baja California, México C.P. 22830
FLOOD LIGHT - "FL" SERIES
INSTALLATION INSTRUCTIONS
IMPORTANT: Make sure application surface can handle weight of light fixture
www.dialight.com for contact information
Tel: 732.919.3119 Fax: 732.751.5778
Document # 9100127212299 Rev.C
September 2014
6
7
Page 1 of 3
www.dialight.com
+52 (646) 156-70-80