Initial Set-Up - Velux VSE KLR 100 User Manual

Initial set-up

Products to be operated with the remote control must be
registered in the remote control. Registration, however,
depends on whether the remote control is new or whether
it is already used for operating other products.
1
• If the remote control is already in operation, proceed
with section Registering new products.
• If the remote control is new, proceed as follows.
When the initial set-up has been completed, the registered
products will appear in the display.
2
Slide off the battery cover of remote control as shown.
Insert the three batteries supplied (type AA, 1.5 volt).
Replace cover.
3
Choose language:
Press to highlight your language.
Press "Enter" to confirm your choice.
4
Prepare products for registration in one of the two follow-
ing ways:
• Disconnect the main power supply to the products for
1 minute and then reconnect it.
• Press the button closest to the side frame of the skylight
(B) once.
The products must now be registered in the remote control
within the next 10 minutes.
8 VELUX
languagE
Eesti
English
Español
Français
Enter
P1
P2
B
A