Whirlpool RS610PXE Job Aid page 17

Refer to the illustration on the following page.
REMOVING AN ELEMENT CONTROL
1. Remove the knob and two mounting screws from the element control you wish to service.
2. Remove the four mounting screws from the cooktop.
3. Lift the cooktop and prop it up (be careful not to scratch the countertop or cooktop).
4. Remove the old element control, then one at a time, disconnect the wires from the terminals,
and reconnect them to the same terminal callouts on the new control.
5. Reassemble the unit.
REMOVING AN INDICATOR LIGHT
1. Remove the cooktop and prop it up (be careful not to scratch the countertop).
2. Slide the old indicator light off the red lens, then one at a time, disconnect the wires from the
terminals of the element controls, and reconnect the wires from the new indicator light to the
same terminals on the controls.
3. Slide the new indicator light onto the red lens.
4. Reassemble the unit.
REMOVING THE COOKTOP HI LIMIT
1. Remove the cooktop and prop it up (be careful not to scratch the countertop or cooktop).
2. Disconnect the two wires from the terminals of the cooktop hi limit.
3. Remove the two screws from the cooktop hi limit and remove it.
4. Reassemble the unit.
REMOVING THE COOKTOP
1. Remove the knobs and the screws from the four element controls.
2. Remove the screw from the four element connector sockets and unhook them from the
cooktop.
3. Remove the green ground wire screw from the right rear burner opening.
4. Unclip the indicator light from the red lens and remove the lens and control panel from the
cooktop.
5. Remove the cooktop from the range.
- 13 -