Kenwood KDC-X500 Instruction Manual page 23

BLUETOOTH®
Settings in memory
Store a contact in memory
You can store up to 6 contacts into the number buttons (1 to 6).
1
Press to enter Bluetooth mode.
2
Turn the volume knob to select [CALL HISTORY], [PHONE BOOK], or
[NUMBER DIAL], then press the knob.
3
Turn the volume knob to select a contact or enter a phone number.
If a contact is selected, press the volume knob to show the phone
number.
Press and hold one of the number buttons (1 to 6).
4
"STORED" appears when the contact is stored.
To erase a contact from the preset memory, select [NUMBER DIAL] in step
and store a blank number.
Make a call from memory
1 Press to enter Bluetooth mode.
Press one of the number buttons (1 to 6).
2
3
Press the volume knob to call.
"NO MEMORY" appears if there is no contacts stored.
Other settings
1
Press the volume knob to enter [FUNCTION].
2 Turn the volume knob to select an item (see the following table),
then press the knob.
3 2
Repeat step until the desired item is selected/activated or follow
the instructions stated on the selected item.
4
Press and hold
To return to the previous setting item, press
JS_KWD_KDC_X500_KW_EN_00_2.indd 19
to exit.
.
BT MODE
PHONE SELECT
Selects the phone or audio device to connect or disconnect.
" " appears in front of the device name when connected.
*
• You can only connect a maximum of two Bluetooth phones and one
AUDIO SELECT
Bluetooth audio device at any time.
DEVICE DELETE 1 Turn the volume knob to select a device to delete, then press the
knob.
2 Turn the volume knob to select [YES] or [NO], then press the knob.
PIN CODE EDIT Changes the PIN code (up to 6 digits).
(0000) 1 Turn the volume knob to select a number.
2
2 Press S / T to move the entry position.
Repeat steps
3 Press the volume knob to confirm.
RECONNECT ON: The unit automatically reconnect when the last connected
Bluetooth device is within range. ; OFF: Cancels.
AUTO PAIRING ON: The unit automatically pair supported Bluetooth device (iPhone/
iPod touch/ Android device) when it is connected through USB input
terminal. Depending on the operating system of the connected device,
this function may not work. ; OFF: Cancels.
INITIALIZE YES: Initializes all the Bluetooth settings (including stored pairing,
phonebook, and etc.). ; NO: Cancels.
1 and 2 until you finish entering the PIN code.
ENGLISH
10/7/2015 5:02:03 PM
Default: XX
19