Table of Contents
Advertisement
Notice!
Remove the battery/batteries from the model when it is not in use.
Notice!
Do not expose the model to strong humidity, hot or cold temperatures or contamination.
Notice!
Do not expose the model for extended periods to strong sunlight or the radiating heat of hot lamps. The different
expansion coefficients of the hull and wooden deck materials can cause cracks.
Notice!
Protect the model and transmitter against damage or slipping while they are being transported.
Notice!
Pay particular attention to the model's water-tightness. A model boat will sink if it takes on too much water. Prior to
every use, check the model for any damage and also ensure the hull is watertight where drive shafts and rudder control
shafts penetrate the hull.
Notice!
Let the model dry off good after it is used.
Notice!
Be sure to check the water-tightness of shaft penetrations through the hull several times during the model's maiden
voyage. If water is intruding, remove the shafts and lubricate the stern tube with sufficient grease (order no. 570).
Notice!
The electric motors built into the model may not be thrown away along with household waste. They must be removed
and turned in at an appropriate disposal facility.
Notice!
If batteries are connected in parallel they may only be so connected when the model is operated as otherwise reciprocal
effects could take place between the batteries and cause them damage. Therefore, connect batteries only just before
running the model and disconnect them again afterward. Batteries must never be stored with connected parallel wiring.
Care!
Clean the model after every use. Remove any water which may have intruded. If water has gotten into RC components,
lay them out to dry then send them to the responsible GRAUPNER service center for inspection.
Care!
Clean the model and transmitter only with suitable cleaning materials. A lint-free cloth is suitable. Never use chemical
cleaning agents, solvents, gasoline, spirits or similar.
Care!
After operating the mode, lubricate drive shafts with a small drop of oil on the bearings. The outer shaft bearings for the
propellers must also be lubricated. To lubricate the drives, use only oil which does not contaminate or pollute water
(e.g. order no. 206). At the end of the operating season, the shafts should be removed and lubricated anew with a
water-neutral grease (e.g. order no. 570).
Declaration of Conformity
CE - Guidelines
The described products meet applicable and mandatory EU directives.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
No liability for printing errors. Technical changes reserved!
7
03/2012
Advertisement
Table of Contents
