Specify the operation interval.
Onetime: Runs the task once.
Hourly: Specify the operation frequency in units of
hours. (Possible set value: 1 to 99)
Daily: Specify the operation frequency in units of
days. (Possible set value: 1 to 99)
Weekly: Specify the operation frequency in units
of weeks and days of the week. (Possible set value:
1 to 99)
Range of recurrence
Specify the starting date and time, and the end date
Start: Set the starting date.
Execution time: Set the starting time.
No end date: This setting does not set an end date.
End after: Specify the number of times to execute
End by: Set the end date.
Check the setting when the final confirmation
screen for task setting is displayed.
If correction is needed, click Back to return to the
previous screen to redo the setting.
Configuring the device setting
You can configure advanced settings for a device on the
Device Setting screen.
When you select a device(s) on the Device list and select
Device Setting from the Tools menu, or when you right
click on the device selection screen and click Device
Setting in the displayed menu, the Device Setting screen
All settings are sorted into categories. Click + to display
the subcategories under a category. Click – to hide the
Select a subcategory to display setting items on the right
side of the screen.
Displays the setting items. Select a line to change its
Displays the value of an item. Select or enter a value to
change the value.
Displays the range of value for setting and
Apply the setting and close the Device Setting screen.
The main screen of SNC Toolbox is displayed.
Close the Device Setting screen without changing the
setting. The main screen of SNC Toolbox is displayed.
Apply the setting.
See the relevant pages in "Administrating the Camera"
when configuring the settings.
Pages to refer to in
"Configuring the System —
System Menu" on page 33
"System Tab" on page 33
"Date & time Tab" on
"Superimpose Tab" on
"Installation Tab" on
"Initialize Tab" on page 37
Using the SNC toolbox