Display Message - Mercedes-Benz 2016 Sprinter Operator's Manual

Display messages
Highbeam Assist
inoperative
Highbeam Assist tem‐
porarily unavaila‐
ble
Engine
Display messages
Exhaust Filter:
Drive at high
engine speed. See
Oper. Manual
Check Diesel
Exhaust Fluid See
Operator's Manual
å
XX starts remaining
Possible causes/consequences and M Solutions
Highbeam Assist is faulty.
Visit a qualified specialist workshop.
X
Highbeam Assist is deactivated and temporarily inoperative.
Possible causes are:
The camera's functionality is impaired due to heavy rain, snow or
R
fog.
The windshield is dirty in the camera's field of vision.
R
Stop the vehicle paying attention to road and traffic conditions.
X
Secure the vehicle to prevent it from rolling away (
X
Clean the windshield (
X
field of vision.
If the malfunction has been rectified, the
available again message appears.
Possible causes/consequences and M Solutions
The automatic regeneration of the diesel particle filter is not sufficient
or has malfunctioned.
Drive at an engine speed of above 2000 rpm until the display mes-
X
sage disappears.
If the display message does not go out after approximately
20 minutes, have the malfunction rectified immediately at a quali-
fied specialist workshop.
The DEF supply has dropped below 1.5 US gal (5.5 l).
Add DEF supply ( page 129).
X
Y
The display message only disappears when the vehicle is stationary,
at the latest after 20 seconds as soon as you switch on the ignition
or start the engine after refueling.
Three short warning tones also sound.
After the message appears for the first time, the remaining DEF supply
will last for approximately 1200 miles (1900 km). The engine can then
only be started another 16 times.
The number of remaining engine starts
message every time the engine is started.
Add at least 1.5 US gal (5.5 l) of DEF (
X
Display messages
page 235), particularly in the camera's
Y
Highbeam Assist
xx (16 to 0) is shown in the
page 129).
Y
187
page 130).
Y
Z