Operation With The Remote Control - Mercedes-Benz 2016 Sprinter Operator's Manual

On-board computer with steering wheel
buttons
Turn the key to position 2 in the ignition lock.
X
Press the y button.
X
The Aux. heat submenu is shown in the dis-
play.
If no switch-on time has been selected, the
selected switch-on time is highlighted or
Timer off is highlighted.
i
You can also access the
menu via the Settings
Use the W or X button on the steering
X
wheel to select the desired switch-on time.
Use the Timer off
automatic switch-on.
Press the V button on the steering wheel.
X
The switch-on time is selected. The yellow
indicator lamp in the y button lights up.
Setting the switch-on time
Use the same method to select a switch-on
X
time as described in the "Preselecting a
switch-on time" section.
On-board computer without steering wheel
buttons
Press the 9 reset button on the instrument
X
cluster.
The hour display flashes.
Use the f and g buttons on the instrument
X
cluster to set the hours.
Press the 9 reset button
X
The minute display flashes.
Use the f and g buttons to set the minutes.
X
The switch-on time is set and selected.
On-board computer with steering wheel but-
tons
Press the 9 button on the steering wheel.
X
The display shows the
Use the W and X buttons on the steer-
X
ing wheel to set the hours.
Operating the auxiliary heating system
Aux. heat. sub-
( page 168) menu.
Y
setting to deactivate
Hours menu.
Press the 9 button.
X
The display shows the
Use the W and X buttons to set the
X
minutes.
Press the V button.
X
The switch-on time is set and selected.

Operation with the remote control

Important information
You can switch the auxiliary heating on/off and
set the operating duration using the remote con-
trol. You can use up to 4 remote control units on
the vehicle. These must be synchronized for the
receiver in your vehicle (
The remote control has a maximum range of
approximately 600 meters. This range is
reduced by:
sources of interference
R
solid objects between the remote control and
R
the vehicle
the remote control being in an unfavorable
R
position in relation to the vehicle
transmitting from an enclosed space
R
Overview of the remote control
: Indicator lamp
; To confirm settings
To switch the remote control on/off, set the
=
operating duration or end or cancel settings
Indicator lamp : lights up in various ways to
show different operating modes:
Signaling Meaning
Lights up red Remote control switched on
Data transfer
Minutes menu.
page 110).
Y
Z
109