Starting Up - Gabarron CTP10 User Manual

Starting up

Turn the knob to Shutdown and
press the right-hand button for
5 seconds until H100 vx:xx is
displayed (maintenance menu
reserved for the installer).
Press OK.
The screen displays CF01.
CF01 - Correction of room temperature
measurement
If there is a difference between
the temperature noted
(thermometer) and the temperature
measured and displayed by
the unit, the menu acts on
the measurement of the probe so
as to compensate for this difference (from -4°C to +4°C
in steps of 0.1°C).
Press + or - to make your choice, OK to confirm it and
go to the next menu.
5 sec.
- 26 -
CF02 - AUTO mode
temperature display option
Temperature displayed
Press + or - to make your choice, OK to confirm it and
go to the next menu.
CF03 - Control of the
Comfort temperature
Controlling the Comfort
temperature
Press + or - to make your choice, OK to confirm it and
go to the next menu.
Continuous room temperature
display
Continuous display of the set-point
Temperature controlled by the thermostat
Temperature controlled by the heating
element. Here, the display reads ON
during Comfort period.
- 27 -