York YEHJZH009-24BAM1ABX User Manual page 14

Introduction for buttons on remote controller
(4) When setting the initial temperature 30 , under this temperature setting, after
7hours, the temperature will be decreased 1 , after that the unit will keep on
running under this temperature;
In Heat mode:
(1) Under the initial presetting temperature 16 , it will run under this setting tem-
perature all along.
(2) Under the initial presetting temperature17 -20 , after Sleep function started
up, the temperature will decrease 1
temperature will be maintained.
(3) Under the initial presetting temperature 21 -27 , after Sleep function started
up, the temperature will decrease 1
temperature will be maintained.
(4) Under the initial presetting temperature 28 -30 , after Sleep function started
up, the temperature will decrease 1
temperature will be maintained.
Sleep 3 - the sleep curve setting under Sleep mode by DIY:
(1) Under Sleep 3 mode, press "Turbo" button for a long time, remote controller en-
ters into user individuation sleep setting status, at this time, the time of remote
controller will display "1hour", the setting temperature "88" will display the corr-
esponding temperature of last setting sleep curve and blink (The first entering
will display according to the initial curve setting value of original factory);
(2) Adjust "+" and "-" button, could change the corresponding setting temperature,
after adjusted, press "Trubo" button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer postion on the
remote controller, (that are "2hours" or "3hours" or "8hours"), the place of se-
tting temperature "88" will display the corresponding temperature of last setting
sleep curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8hours temperature setting finished,
sleep curve setting finished, at this time, the remote controller will resume the
original timer display; temperature display will resume to original setting tem-
perature.
Sleep3 - the sleep curve setting under Sleep mode by DIY could be inquired:
The user could accord to sleep curve setting method to inquire the presetting sleep
curve, enter into user individuation sleep setting status, but do not change the tem-
perature, press "Turbo" button directly for confirmation.
Note: In the above presetting or enquiry procedure, if continuously within10s, there
is no button pressed, the sleep curve setting status will be automatically quit
and resume to display the original displaying. In the presetting or enquiry pr-
ocedure, press "ON/OFF" button, "Mode" button, "Timer" button or "Sleep"
button, the sleep curve setting or enquiry status will quit similarly.
in every hour, after 1
in every hour, after 2
in every hour, after 3
12
decreased, this
decreased, this
decreased, this