Standard Accessories; Specifications - Hitachi DS 18DBL2 Handling Instructions Manual

NAMES OF PARTS (Fig. 1 – Fig. 16)
Rechargeable battery
1
Latch
2
Handle
3
Charge indicator lamp
4
Rubber cap
5
Protruding portion of
6
the side handle
Side handle
7
Drill mark
8
Clutch dial
9
Triangle mark
0
Hammer mark
!
Shift knob
@
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
DS18DBL2: Cordless Driver Drill
DV18DBL2: Cordless Impact Driver Drill
Read all safety warnings and all instructions.
Direct current
V Rated voltage
n
No-load speed
0
/min Oscillation per minute
Bpm Impact rate
Ls Low speed
Hs High speed
Brick
Wood
Metal
Machine screw
Wood screw
Drill chuck capacity
Weight
kg
Drilling
Impact drilling
Switching ON
Switching OFF
Screw
#
Hook
$
Groove
%
Trigger switch
^
Remaining battery
&
indicator lamp
Display panel
*
Sleeve
(
Push button
)
Rubber cover
q
USB port
w
USB cable
e
Disconnect the battery
Change rotation speed - High speed
Change rotation speed - Low speed
Clockwise rotation
Counterclockwise rotation
The battery remaining power is nearly empty.
Recharge the battery soonest possible
The battery remaining power is a half.
The battery remaining power is enough.
Warning

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 10.
Standard accessories are subject to change without notice.
APPLICATIONS
<DS18DBL2>
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
○ Drilling of various metals
○ Drilling of various woods
<DV18DBL2>
○ Drilling of brick and concrete block, etc.
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
○ Drilling of various metals
○ Drilling of various woods

SPECIFICATIONS

The specifi cations of this machine are listed in the Table on
page 10.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
When connecting the plug of the charger to a receptacle,
the pilot lamp will blink in red (At 1- second intervals).
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in Fig. 2.
3. Charging
When inserting a battery in the charger, the charge
indicator lamp will blink in blue.
When the battery becomes fully recharged, the charge
indicator lamp will light up in green. (See Table 1)
(1) Charge indicator lamp indication
The indications of the charge indicator lamp will be as
shown in Table 1, according to the condition of the
charger or the rechargeable battery.
5