power source and/or battery pack, picking up or GENERAL POWER TOOL SAFETY carrying the tool. WARNINGS Carrying power tools with your fi nger on the switch or energising power tools that have the switch on WARNING invites accidents. Read all safety warnings and all instructions. d) Remove any adjusting key or wrench before Failure to follow the warnings and instructions may result in turning the power tool on.
c) When battery pack is not in use, keep it away 9. Do not dispose of the battery in fi re. If the battery is burnt, from other metal objects, like paper clips, coins, it may explode. keys, nails, screws or other small metal objects, 10.
WARNING REGARDING LITHIUM-ION BATTERY In order to prevent any battery leakage, heat generation, TRANSPORTATION smoke emission, explosion and ignition beforehand, please be sure to heed the following precautions. When transporting a lithium-ion battery, please observe the 1. Make sure that swarf and dust do not collect on the following precautions.
The specifi cations of this machine are listed in the Table on page 10. Low speed High speed NOTE Due to HITACHI’s continuing program of research and Brick development, the specifi cations herein are subject to change without prior notice. Wood...
Page 6
Table 1 Indications of the charge indicator lamp Lights for 0.5 seconds. Does not light for Before Blinks 0.5 seconds. (off for 0.5 seconds) Plugged into power source charging (RED) Lights for 0.5 seconds. Does not light for Blinks 1 second. (off for 1 second) Battery capacity at less than 50% (BLUE) While...
CAUTION When this function activates, it will be indicated by the LED ○ If the battery is charged while it is heated because light blinking (0.1-second blinks/off 0.5 seconds) while the it has been left for a long time in a location subject to switch is pulled.
The motor unit winding is the very “heart” of the power tool. Exercise due care to ensure the winding does not Important notice on the batteries for the Hitachi become damaged and/or wet with oil or water. cordless power tools 4.
Page 9
The charger’s vents are blocked, causing its Avoid blocking the vents. internal components to overheat. The cooling fan is not running. Contact a Hitachi Authorized Service Center for repairs. The USB power lamp The battery’s capacity has become low. Replace the battery with one that has has switched off...