Toyota 2006 Hilux Mk6 Owner's Manual page 50

13H085
To install the baby (infant) seat:
1. Run the lap and shoulder belt through
or around the baby (infant) seat follow-
ing the instructions provided by its
manufacturer and insert the tab into
the buckle taking care not to twist the
belt. Keep the lap portion of the belt
tight.
34
13H041
2. Install a locking clip near the tab of
the lap and shoulder belt by inserting
the lap and shoulder webbing through
the recesses of the locking clip. Buckle
the belt again. If the belt has any
slack, release the buckle and reinstall
the locking clip.
If your child restraint system does not
provide a locking clip, you can purchase
one at your Toyota dealer. (See "—Child
restraint system" on page 31.)
CAUTION
D
After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
D
Do not insert coins, clips, etc. in
the buckle as this may prevent you
from properly latching the tab and
buckle.
D
If the seat belt does not function
normally, it cannot protect
child from death or serious injury.
Contact your Toyota
immediately. Do not install the child
restraint system on the seat until
the seat belt is fixed.
your
dealer