Page 1
MANUALE DI ISTRUZIONI MT 2WD Monster Truck. Dieses 1:10 Scale Model öffnet Ihnen die Welt des RC Car Sports. Nous vous félicitons pour l’achat du ECX AMP MT 2WD Monster Truck. Ce modèle 1:10 vous introduit au sport de la conduite RC.
NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit http://www.horizonhobby.com and click on the support tab for this product. Meaning of Special Language The following terms are used throughout the product literature to indicate various levels of potential harm when operating this product: NOTICE: Procedures, which if not properly followed, create a possibility of physical property damage AND little or no possibility of injury.
WATER-RESISTANT VEHICLE WITH WATERPROOF ELECTRONICS Your new Horizon Hobby vehicle has been designed and built with a excessively wet, apply very light throttle until the water is mostly combination of waterproof and water-resistant components to allow you to removed from the motor. Running a wet motor at high speeds may rapidly operate the product in many “wet conditions,”...
GETTING STARTED Charge the battery 2 Assemble the AMP Monster Truck 3 Paint the AMP Monster Truck 4 Install the battery 5 Setup the transmitter 6 Drive! CHARGING WARNINGS WARNING: Failure to exercise caution while using this product charge batteries such as “heavy duty,” “alkaline,” “mercury” or and comply with the following warnings could result in product “lithium”...
STEP 2: ASSEMBLE THE AMP MONSTER TRUCK Thank you for purchasing the AMP Monster Truck Kit. The kit number of parts to build the AMP Monster Truck. Open the "Tools" includes 6 bags marked A–F. Each bag contains secondary bags bag first.
STEP 3: PAINT AND STICKER THE AMP MONSTER TRUCK BODY SHELL 1. Clean the inside of the AMP MT body shell using a small amount of 2. Paint the inside of the AMP MT body shell. water and dish soap. Thoroughly rinse and dry the body shell with a 3.
STEP 5: SET UP THE RADIO SYSTEM BINDING 1. Remove the battery cover from the transmitter. While pressing the bind button, power on the vehicle (small push button 2. Install four AA batteries as shown. located within the on/off switch). The receiver will blink red. Power on your 3.
STEP 6: DRIVE Power on the transmitter. Power on the ESC. Drive! WHEN YOU ARE FINISHED Power off the ESC. Power off the transmitter. Remove and recharge the battery pack. ELECTRONIC SPEED CONTROL (ESC) Connecting Calibrating 1. Connect the RED (+) ESC wire to the RED (+) motor wire. Ensure proper ESC function by calibrating the ESC to your transmitter inputs.
TROUBLESHOOTING GUIDE Problem Possible Cause Solution Short Run Time • Battery damaged/not charged • Check/change battery • Motor dirty • Check/clean Sluggish Action • Motor dirty • Check/clean • Bind in drivetrain • Clean/adjust • Vehicle battery is not charged • Replace/recharge Controls Reversed • ST.
LIMITED WARRANTY What This Warranty Covers Inquiry, or call the toll free telephone number referenced in the Warranty and Service Contact Information section to speak with a Product Support Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the representative.
WARRANTY AND SERVICE CONTACT INFORMATION Country of Purchase Horizon Hobby Contact Information Address Horizon Service Center servicecenter.horizonhobby.com/RequestForm/ (Repairs and Repair Requests) 4105 Fieldstone Rd United States of Horizon Product Support productsupport@horizonhobby.com Champaign, Illinois America (Product Technical Assistance) 877-504-0233 61822 USA websales@horizonhobby.com Sales 800-338-4639...
Need help?
Do you have a question about the AMP mt ECX03034 and is the answer not in the manual?
Questions and answers