Axis MTC--GM-LP Owner's Manual page 9

ASSEMBLY INSTRUCTIONS
Warning:This appliance requires installation by a
competentperson. Proper assembly is the
responsibility of the installer.
Step3: Insert M6x35 thumb screw into hole A, and M6x12
thumb screw into hole B. Lock the screws.
CAUTION!
After raising and pivoting heat exchange tube, tighten two
thumb screws to lock into place. Failure to do so could
allow heat tube to drop during use. Tighten screws before
operation!
Step4: Fully open gas chamber door. Place control
knob on control stem.
Remove the knob from control stem and store it inside the
bracket inside the door when you lower down the heat
exchange tube, and don't use the heater for a long time.
Step 3
B
A
Step 4
8
2
1