Operation - Axis MTC--GM-LP Owner's Manual

OPERATION

WARNING: DO NOT ATTEMPT TO OPERATE HEATER UNTIL YOU HAVE READ AND
UNDERSTAND ALL PRECAUTIONS. FAILURE TO DO SO CAN RESULT IN SERIOUS
PERSONAL INJURY, DEATH, OR PROPERTY DAMAGE.
Before turning gas supply ON
Your heater was designed and approved for OUTDOOR
USE ONLY. DO NOT use it inside a building or any other
enclosed area.
Make sure surrounding areas are free of combustible
materials, gasoline, and other flammable vapors or liquids.
Ensure that there is no obstruction to air ventilation.
Be sure all gas connections are tight and there are no leaks.
Be sure the access panel is clear of debris.
Be sure any component removed during assembly or
servicing is replaced and fastened prior to starting.
Before Lighting
Heater should be thoroughly inspected before each use,
and by a qualified service person at least annually.
If relighting a hot heater, always wait at least 5 minutes.
Lighting instructions
1) Turn the control knob to "OFF" position.
2) Turn LP cylinder gas valve to fully open position.
3) Turn knob counter-clockwise to "IGNITE". Hold knob
down to activate "IGNITE" until lit. (It is also possible to
ignite the appliance using a long match, by approaching
the burner through the ignition hole provided.)
If pilot does not light, turn knob clockwise to "OFF". Wait
5 minutes and repeat the procedure.
FOR YOUR SAFETY:
If at any time you are unable to
light burner and smell gas, wait 5
minutes to allow gas to dissipate
before attempting to light heater.
If after 1 minute, you are unable
to light burner, wait 5 minutes
and allow flammable vapors to
dissipate before attempting to
light heater.
FOR YOUR SAFETY:
DO NOT touch or move heater
for at least 45 minutes after use.
Allow emitter and heat reflector
to cool before touching.
Lighting operations should
comply with Lighting Instruction
section. Improper lighting
operations will cause serious
injury and explosion.
11
WARNING
WARNING
WARNING