Sinclair SP-300A User Manual page 14

Hide thumbs Also See for SP-300A:
Table of Contents

Advertisement

Thoubleshooting
Please reaffirm the problems before asking for maintenance.
Symptoms
The remote control
does not work
Can not start
There is no air blowing
Do not achieved the
cleaning effect
The TV signal is in
interference
It smells in the air outlet
Check
Whether the battery is dead?
Are the positive and negative
poles installed reversely?
Does indoor fluorescent light
keep flickering for the reason
of lifespan?
Is the power plugged in?
Is the panel correctly installed?
Is it installed in unventilated
areas or are there any obstacles
near the machine?
Is there too much dust on the
filter components, filter cotton
and HIMOP + HEPA filter
components?
Is there too much odor and
smoke produced?
Are there any TV, radio within 2
meters away from the machine
or is there any indoor antennas
near the machine?
Are there any power cords or
television sets, radio antenna
which are close to the machine?
Is there lots of smell released
temporarily?
(Many
smoke or barbecue.)
Is the activated carbon filter not
cleaned or replaced for a long time?
Processing method
Replace with new battery
Install the battery correctly
Keep the machine in a distance
from the fluorescent
Plug the power supply
I Plug the power supply
Please contact the after-sales
service in this case
Remove obstacles
Clean the filters, and replace
filter cotton
Clean activated carbon filters
Move the TV, radio, and indoor
antennas more than 2 meters
away from the machine.
Keep the power lines or television
sets, radio antenna as far as
possible away from the machine.
The smell will be gradually
disappearing when the machine
people
runs for some time.
Maintain the activated carbon filters

Advertisement

Table of Contents
loading

Table of Contents