Advertisement
6 - GB
Chapter 2.1: Regulating the Soleplate Temperature
Select the temperature of the soleplate by turning the dial on the iron to the desired position.
Wait a few moments until the temperature indicator is off.
It will indicate to you that the soleplate has reached the requested temperature.
While ironing, the temperature dial indicator may turn on and off, the temperature
adjusts without interrupting your ironing.
Help
To know the best suitable temperature for each textile, check the laundry care label
of the article to be ironed. Please note that during use, the temperature light goes on
from time to time. It signifies that the iron is heating up to the set temperature.
If a fabric is made with various kinds of fibres always select the soleplate temperature
to suit the most delicate one .
If you select a lower temperature while ironing, wait until the iron has cooled down to
the set temperature before you continue ironing.
If the temperature is too low, some drops of water could escape from the soleplate.
Please raise up the temperature above the 2 dots (••) to avoid this issue.
Chapter 2.2 - Ironing
Dry ironing
For dry ironing, turn the steam control knob to "0"or "
flow if water is in the water tank.
Turn the temperature control knob to select the desired fabric/temperature setting.
The indicator power light will illuminate, ensure the iron is on a smooth and stable
surface vertically.
After the indicator power light goes out, you can begin to iron.
Steam ironing
As indicated on the temperature control and the table on the rear of the iron, steam-
ironing is only possible at higher ironing temperatures (between "●●" to "MAX").
Ensure that there is enough water in the water tank.
Stand the iron on its end; Insert the mains plug into the wall socket.
Set the temperature control knob at the required position within the steam area.
After the indicator power light has gone out and has come on again, you may start
ironing.
aTTEnTiOn: Never direct the steam towards people. Burns or serious injury may occur.
Cooling Feature *
Turn on the fan by pushing FAN SWITCH to cool the handle and user environment.
Push again to turn it off.
" . This will cut off the steam
* Certain Models Only
Advertisement
