Advertisement
9 - GB
Chapter 2-10 Auto Shut off function
a. The auto-shut-off function automatically switches off the iron if it has not been
moved after 30 secs in horizontal position or after 8 mins in vertical position.
b. The power light starts flashing to indicate that the iron has been switched off by
the auto-shut-off function.
c. To let the iron heat up again:
1. Move your iron in one complete motion from the vertical position to horizontal
returning to the vertical position
2. if the temperature of the soleplate has dropped below the setting ironing
temperature, the power light will turn on, please waiting until it goes out before you
start ironing.
3. If the power light does not turn on after you move the iron, the soleplate still has
the right temperature and the iron is ready to use.
Chapter 3: Maintenance and Cleaning
To prevent any risk of burns, all maintenance and cleaning operations should only be
carried out when the unplugged appliance has cooled down for at least 2 hours.
Before cleaning, set the steam control knob to the "0" or "
wall socket, and allow the appliance to completely cool down, and then clean with a
damp cloth, do not immerse the unit into water or other liquids.
Clean and empty the water tank after every use.
If ironing clothes with high temperature, which is not recommended on the garment
table, this will cause burns to your clothes and residue left on the soleplate of the unit,
it is recommended that you iron over an old cloth to remove any residue from the
soleplate.
After use, set the steam control knob to the "0" or "
mains socket, empty remaining water from water tank and then store the iron after it
has been completely cooled down.
Never use scouring pads, abrasive or chemical cleaners, or solvents
Chapter 4: Storage
Empty the water tank.
Coil the power cord on the back plate.
Put the iron in the upright position on it's heel.
Wait at least 30 minutes allowing the sole plate to cool down.
Then you can take away your appliance in order to store it safely and easily.
Important Information
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your local
Hoover dealer or direct from Hoover. When ordering spare parts, always check your
model number.
Hoover Service
Should you require service at any time, please contact your local Hoover Service Office.
Please see all the contact details below.
", unplug the iron from
", disconnect the unit from
Advertisement
