Field.programming.mode - Vertex Standard VX-4600CB Operating Manual

The Memory Channel of the RX Only Group allows the user to change the receiv-
ing frequency while the VX-4600CB is in the Field Programming mode.
1. Turn the radio "off".
2. Press and hold in the [ p ] key while turning the radio on. Release the [ p ] key
after "FIELDPRG" appeared. The radio enters the Field Programming mode.
3. Press the [ p ] / [ q ] key to select the Memory Channel which you wish to
change the frequency.
4. Press the [ P4 ] key briefly. The memory channel number will blink.
If you wish to disable the current channel (leave from Memory Channel list),
press the [ p ] / [ q ] key to change the blinking memory channel number to the
blinking "NONEXIST" notation, then skip to step 8.
Note: The memory channel "1" can not set to "disabled".
5. Press the [ P4 ] key briefly, then press the [ p ] / [ q ] key to select the desired
bandwidth between "SEP WIDE" (Wide: 25 kHz/step) or "SEP NARR"
(Narrow: 12.5 kHz/step).
6. Press the [ P4 ] key briefly, and then press the [ p ] / [ q ] key to change the re-
ceiving frequency by 1 MHz step.
7. Press the [ P4 ] key briefly, and then press the [ p ] / [ q ] key to change the re-
ceiving frequency by the step which was determined in step 5.
8. Press the [ P4 ] key to save the new frequency.
9. If you wish to change other memory channel, repeat steps 3 through 8 above.
10. After completing your programming, turn the radio off by pressing the
PWR ( ) button for 2 seconds to save the new settings.
20
f p
Ield rogrammIng
m
ode
VX-4600CB O
perating
M
anual