Adding Engine Oil - BMW 3 SERIES Owner's Manual

Hide thumbs Also See for 3 SERIES:
Table of Contents

Advertisement

1.
Push button 1 in the turn signal/high beam
lever up or down repeatedly until the appro-
priate symbol is shown in the display,
accompanied by the word "OIL".
2.
Press button 2 in the turn signal/high beam
lever.
The oil level is checked and the reading dis-
played.
Possible displays
1
Oil level OK
2
Oil level is being checked.
This can take about 3 minutes if the car is at
a standstill on a level surface, or about
5 minutes while the car is on the move.
Online Edition for Part no. 01 40 2 609 312 - © 08/11 BMW AG
Engine compartment
3
Oil level down to minimum:
Add engine oil as soon as possible, but no
more than 1 US quart/1 liter, refer also to
Adding engine oil on page 199.
4
Oil level is too high.
Too much oil will harm the engine.
Have the vehicle checked without
delay.<
5
The oil level sensor is defective.
Do not add engine oil. You can continue
your journey. Note the newly calculated dis-
tance remaining to the next oil service, refer
to page 84. Have the system checked as
soon as possible.

Adding engine oil

Do not add 1 US quart/1 liter of engine oil until
the following warning lamp lights up in the
instrument cluster, or until the oil level monitor
shows "+1qt" or "+1l".
Add oil within the next 125 miles/200 km;
otherwise, the engine could be dam-
aged.<
Mobility
199

Advertisement

Table of Contents
loading

Table of Contents